Each version have 1 to 10 different questions or more. If no, explain the difference s. In this tutorial we will discuss about 6. Step 2: Test end-to-end connectivity across the network. While you take online test with netacad. Part 1: Display Router Information Step 1: Display interface information on R1. In this activity, you will finish documenting the network.
What command did you use? In addition, you should be able to ping the active interfaces on the routers. Authoring and localization of structured learning activities such as labs, demonstrations, quizzes, exams, remote instructor-student interactions and games. Review the steps in Part 2. In addition, you will determine an appropriate solution for implementation in Part 2. I have started but do not think that I can get it all done. Note: The serial interfaces are already configured and active.
Note: Often there is more than one solution. The latest version is version 6. It depends on your instructor creating your class. This is done so that this activity is 1 consistent with examples shown in the chapter, 2 ready to provide complete output from show commands when the student configures and activates the Ethernet interfaces. It depends on your instructor creating your class.
A verification plan can be as simple as a list of connectivity tests. I am currently stuck on 5. My teacher said I had to do all of them in one week and a half. We recommend you to go thought all version if you are not clear. The default gateway is used when the host wants to send a packet to a device on another network.
Part 2: Implement, Verify, and Document Solutions In Part 2 of this activity, you will implement the solutions you identified in Part 1. Providing valuable hands-on experience that can be applied in the classroom and on the job. Some of the configurations are not covered in this course, but are provided to assist you in using verification commands. R1 has 6 Ethernet interfaces and R2 has 2 Ethernet interfaces. I have most of these at 85% considering all you are doing in line con 0, line vty 0 15, hostname ip address, protocols, etc.
The console password is cisco. You can email me a jbmet93 gmail. Finally, you will use commands to verify and test your configurations. Use the following tests to verify local connectivity and isolate any access issues. We recommend you to go thought all version if you are not clear. Each router has 2 serial interfaces. You will then use the Addressing Table to configure router Ethernet interfaces.
Note: For simplicity in this activity, the switches are not configured; you will not be able to ping them. Gigabit Ethernet interfaces support speeds of up to 1,000,000,000 bits and Fast Ethernet interfaces support speeds of up to 1,000,000 bits. There are two Gigabit Ethernet interfaces and 4 Fast Ethernet interfaces. Adding instructional text for students as well as grading and real-time feedback, which provides an unlimited number of guided learning experiences. Note: The routers in this activity are partially configured.
Enhancing Packet Tracer by adding on curriculum and assessment delivery, games, accessibility and interfacing with real equipment. However, it is a troubleshooting best practice to implement one solution at a time. Each version have 1 to 10 different questions or more. If you have any anything I would greatly appreciate it. A router will only send packets to a network listed in the routing table. Test connectivity to devices on the same network. By isolating and correcting any local access issues, you can better test remote connectivity with the confidence that local connectivity is operational.
While you take online test with netacad. . Activities can also be saved and shared with others in the Networking Academy community. Thanks in advance : ccna exploration 4. You may need to return to Part 1 to finish isolating all the problems.
From year to year, Cisco has updated many versions with difference questions. Notice in the Addressing Table that some information is missing. Step 3: Display the routing table on R1. From year to year, Cisco has updated many versions with difference questions. Just wondered if someone can e-mail me the completed packet tracers so I may figure out what I did wrong or haven't done yet. Step 2: Determine an appropriate solution for the problem. The default gateway address is generally the router interface address attached to the local network to which the host is connected.